Application Instructions for Patterned HTV

Patterned HTV Application Instructions: (heat press)

  • First, cut and weed material
  • Next, mask with Magic Mask – Medium Tack
  • Use mask to peel design from backer
  • Apply design at 295°F/146°C with medium pressure for 15 seconds
  • Finally, peel hot

Patterned HTV Application Instructions:  (home iron) 

  • First, cut, weed material
  • Next, mask design using Magic Mask – Medium Tack
  • Use mask to peel design from backer.
  • Set iron dial between Cotton and Linen
  • Cover design with Kraft paper or non-stick cover sheet (Teflon)
  • Place on flat, hard surface (ironing board not recommended)
  • Press iron with medium/firm pressure (do not slide iron)
  • Press each section of design for 10-15 seconds
  • If areas of design lift after application, replace cover sheet and re-press for 5-10 seconds
  • Finally, peel carrier hot or cold

Patterned Glitter HTV: Application Instructions: (heat press)

  • First, cut and weed material
  • Next, mask with Magic Mask – High Tack
  • Apply design at 302°F/150°C with medium pressure for 12 seconds
  • Finally, peel hot

Glitter Laminate (for adhesive vinyl only)

X